9/5/2023 0 Comments Sail boom clew slug![]() Outhaul slugs are designed specifically for use at the clews of mainsails where a good amount of stress is focused. Line Size 6mm (1/4') Variations: Run line through clew eye and fix at boom end to increase purchase to 4:1. It's only been 2 weeks, but so far it's still working like the day I did it (except for the one broken slug). This video demonstrates how to install a Coated Outhaul Slug. When I let the halyard go, the main dropped like a shot, all the way down. Most of today’s mainsails are loose-footed with nothing attaching the sail to the boom other than the tack at the gooseneck and the clew on the outhaul. then I reattached the sail (after replacing the slugs that weren't sewn in) and raised it with almost no effort. After the movement had improved somewhat and the sponge was more-or-less clean, I switched to a dry sponge for a few passes, then another, this time saturated with Mclube or Sailkote, I can't remember which. Then I saturated the sponge with Formula 409 and ran it up the mast with the halyard, and pulled it back down with the messenger line (I made sure my messenger line was long enough to reach the masthead.) I did that slowly about 20 times, using both edges of the sponge and re-applying the 409 each time. ![]() I jammed the top edge of the sponge into the mast track and fed it in so that one long edge of the sponge was inside the track. I used a package of sponges (the kind that have one green scrubber side, about 3" by 5".) I attached the top part of the first sponge to the halyard shackle with a piece of wire, then attached a 'messenger' line to the shackle and wired the lower part of the sponge to it.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |